- OptiMate Products
- >
- Optimate 6 Ampmatic
Optimate 6 Ampmatic
SKU:
$132.99
$120.89
$120.89
Unavailable
per item
T9-step 12V 5A Battery Saving charger-tester-maintainer
SKU: TM-181
OptiMate 6 saves batteries other chargers can’t, because it recognizes the difference between a discharged battery that needs charging and a dead flat sulphated battery that needs saving. Perfect for months-long maintenance of any size 12V lead-acid battery – deep cycle, automotive, marine, motorcycle.
The world’s most advanced fully automatic 12V battery charger!
CHARGING AMPS : 5A (Ampmatic)
USE : Indoor / Outdoor (lowest temperature: -40°F / -40°C).
SAVE : Low Volt Start of 0.5V + 2-step desulphation recovery.
IDEAL FOR : STD, AGM & GEL 12V batteries from 3 – 240Ah.
INPUT : Global (100-240V 50-60Hz), high efficiency (CEC listed), fully sealed.
STYLE : Weatherproof case with wall mounts, with 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector.
INCLUDED: Weatherproof battery lead & standard battery clip set
SAFE: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected. 3-year limited replacement warranty.+
Multi-stage desulphation: Restores neglected batteries from as low as 0.5 Volts. Ampmatic charge control: adjusts current to suit any battery size (3 to 240Ah) OR condition for fastest and most complete charge. Cell voltage balancing mode: correctly prepares NEW batteries for first use and optimizes battery performance. Daily battery condition tests & interactive float charge: maintains battery fully charged, weeks or months long.
SKU: TM-181
OptiMate 6 saves batteries other chargers can’t, because it recognizes the difference between a discharged battery that needs charging and a dead flat sulphated battery that needs saving. Perfect for months-long maintenance of any size 12V lead-acid battery – deep cycle, automotive, marine, motorcycle.
The world’s most advanced fully automatic 12V battery charger!
CHARGING AMPS : 5A (Ampmatic)
USE : Indoor / Outdoor (lowest temperature: -40°F / -40°C).
SAVE : Low Volt Start of 0.5V + 2-step desulphation recovery.
IDEAL FOR : STD, AGM & GEL 12V batteries from 3 – 240Ah.
INPUT : Global (100-240V 50-60Hz), high efficiency (CEC listed), fully sealed.
STYLE : Weatherproof case with wall mounts, with 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector.
INCLUDED: Weatherproof battery lead & standard battery clip set
SAFE: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected. 3-year limited replacement warranty.+
Multi-stage desulphation: Restores neglected batteries from as low as 0.5 Volts. Ampmatic charge control: adjusts current to suit any battery size (3 to 240Ah) OR condition for fastest and most complete charge. Cell voltage balancing mode: correctly prepares NEW batteries for first use and optimizes battery performance. Daily battery condition tests & interactive float charge: maintains battery fully charged, weeks or months long.
TECHNICAL SPECIFICATIONS
- Recommended for AGM/MF, STD, GEL and spiral cell batteries - up to 240Ah
- Programme control - ampmatic microprocessor
- Input current max. - 0,55A @ 230V
- Typical annual energy cost - < €1 (continuous maintenance)
- Reverse drain current - less than 0,001A
- Output current (bulk charge) - 0,4A – 5,0A
- Automatic desulphation - multistage (high voltage, turbo and pulsed mode)
- Charge time limit - 48 hours (maintenance time: unlimited)
- Maintain / test cycles - 30 min/30 min (alternating hourly)
- Charge retention test - Range: 12,2 - 12,7V. GOOD (green) = battery voltage > 12,7V
- Size - 199 x 71 x 61mm
- Weight - 740g
- Enclosure classification - IP54
- Mounting - easy direct wall mounting
- Input cable length - 2m
- Output cable length - 2m
- Included Accessories - O-1 fused eyelet set, weather protected & O-4 clamps set for bench charging
- Operation temperature range - -40°C / +50°C
- Warranty - 3 years